everroll® SF is a robust, impact-absorbing floor covering that is predominantly installed in ingress / egress points and access areas in cableway stations. The product is resistant to the damage that can be caused by ski boots and ski equipment, is optimised for the use of trolleys, and can be installed quickly and easily. Its porous surface allows water to drain through it quickly, helping to prevent the build-up of standing water.
|Material||PUR-bonded rubber granulate on an EPDM basis.|
|Implementation||everroll® SF is supplied as a single layer EPDM plate, and we recommend that the plates are glued to the sub-floor on which they will sit.Each plate has a fake joint along the centre of the longitudinal side.|
|Colours||Three colour options are available. Bespoke colours available on request.|
|Anti-slip resistance||Anti-slip resistance R10 in accordance with BGR 181|
|Installation||The product can be installed on to concrete, asphalt, screed or any other even and durable surfacing material. The plates are glues into position on the underside at the edges.|
|Dimensions||1,000 x 500 x 22 mmTolerances: Length/width ± 1 %, Thickness: ± 2 mm|
|Weight||approx. 26.4 kg/m²|
|Fire behavior||Cfl-s1 in accordance with DIN EN 13501-1|
Click on a sample image to view the colour variant.
The colours in the illustrations may differ from the original for technical reasons. Your buying decision should therefore be considered only after viewing an original sample. Request your sample from BSW today by contacting our experts. Minor colour deviations between different production batches cannot always be avoided. Normally, all floorings of identical colour and pattern will be delivered from the same production run.
Annex XVII Entry 50 REACH contains requirements for articles accessible for the general public. We therefore ask our customers to check whether the intended use of products bought from us complied with this legislation.
Information regarding newly installed plates (when laying outdoors): After the installation of everroll® SF plates, a slight wax discolouration may temporarily occur. This discolouration quickly disappears when the product is subjected to natural weather conditions. The wax is used in the manufacturing process of the plates and once the wax is removed the colours will appear in full luminosity. The colour options of everroll® SF plates are created using a specific manufacturing method and can only be obtained from BSW. Our plates are manufactured using specially selected and certified products. Due to the manual production process, colour deviations and/or different distributions of the various granulates use may occur. To ensure consistency we recommended that the full amount of product is selected and collected at the same time. BSW can also apply extra UV protection upon request. Please enquire for more information.